The way I have my whiteboard set-up is a little awkward but it does the
job. Because of this awkwardness, I used my 3D printer to make a holder for my
whiteboard markers.
Printer Settings
The settings below are the main ones I used when printing the model.
- Layer Height: 0.28 mm
- Infill Density: 20%
- Supports: Yes
- Rafts: No (Doesn't matter)
- Filament: PLA
The figures below are based on using Cura 4.8 and the settings above.
- Estimated Print Time: 6 Hours 36 Minutes
- Material Usage: 62 g, 20.81 m